FoCOM Ford Diagnostic tooldiagnostics software allows you to perform complete diagnostics of
all 1995-present Ford models. Diagnostics is performed via OBD-II
connector (which is located near steering wheel).
Unlike other universal Ford car scanner tools which only read fault
codes, this software performs nearly ALL the functions like the
original dealer diagnostic tool. Our Ford diagnostic interface
contains K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus
(both PWM and VPW).
The following diagnostic functions are supported:
1. Read identificationDisplays complete identification of control
unit, e.g. part number, software/hardware version, manufacturer,
2. Read fault codesDisplays all stored and pending fault codes with
complete description (e.g. "Rail pressure - too low
pressure").Program supports report printing or copy to clipboard.
3. Clear fault codesThis function clears all stored fault codes and
other diagnostic information.
4. Auto-scan (complete car scan/test)Detects all Ford ECUs
(electronic control units) installed in car and reads all
diagnostic fault codes.
5.Measured ValuesProgram displays live Data like Engine Speed,
Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values
can be displayed in graph, 9 values at once, or full listing (all
measured values). Logging to file is also supported, which allows
6. Actuator testActuator test activates particular actuator (e.g.
turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off
7. Programming functions/AdaptationThis feature is of great
importance in all vehicles because systems like Engine control
units, Immobilizers, Airbags, Alarms, Body Control Units, and some
others, require you to perform reset or programming procedures
after car repair is done, or even configuration after replacing
broken Control Unit.
1.English2.Germany3.Czech 4.Hungary:Hungary - Magyar
5.Croatian (hrvatski jezik)6.Netherlands7.turkey
Hardware and software requirements
Software requires at least Intel Celeron/Pentium III 400 MHz, 128
MB RAM, 50MB free HDD space and USB 1.1 port (USB 2.0 recommended)
and Microsoft Windows 98 SR2/2000/XP with the latest service pack